Yardistry YM11635 Guide d'installation télécharger pdf (Page 4)

Instructions for Proper Maintenance

Your Yardistry structure is designed and constructed of quality materials. As with all outdoor

products it will weather and wear. To maximize the enjoyment, safety and life of your structure

it is important that you, the owner, properly maintain it.

Symbols:

Throughout these instructions symbols are provided in the top, right-hand corner of the page.

If you dispose of your Yardistry structure: Please disassemble and dispose of your

unit so that it does not create any unreasonable hazards at the time it is discarded. Be

sure to follow your local waste ordinances.

HARDWARE:

• Check metal parts for rust. If found, sand and repaint using a non-lead paint complying

with 16 CFR 1303.

• Inspect and tighten all hardware after completion of assembly; after rst month of use; and

then annually. Do not over-tighten as to cause crushing and splintering of wood.

• Check for sharp edges or protruding screw threads, add washers if required.

WOOD PARTS:

• Unprotected they will appear weathered over time. Periodic application of an exterior

water repellent or stain (water-based) will help improve appearance and life.

• Check all wood members for deterioration, structural damage and splintering. Sand down

splinters and replace deteriorated wood members. As with all wood, some checking and

small cracks in grain is normal

• Tape Measure

• Carpenters Level

• Standard or Cordless Drill

• #2 Phillips Bit or Screwdriver

• 7/16” Wrench or Socket

Assembly Guides

• 8’ Step Ladder

• Safety Glasses

• Adult Helper

• Gloves

• Hard Hat

Tools Required:

• Use Help, where this is shown, 2 or 3 people

are required to safely complete this step.

To avoid injury or damage to the assembly

make sure to get some help.

• Use a measuring tape to assure proper

location

• Pre-drill a pilot hole before fastening

screw or lag to prevent splitting of wood.

1 2 3 4 5 6 7 8 9 ... 33 34

Pas de commentaire

Yardistry YM11635 Guide d'installation Page 4